Prevents rust, corrosion and fouling
Rust and corrosion need air to grow. With Sweetshooter's™ micro-thin protective film, air can no longer reach the surface of the metal.
With the pores filled with Sweetshooter™, powder residue, leading and fouling are a thing of the past. There will be no place for those harmful deposits to collect except on the SURFACE of the film. Simply wipe it off!
Note: Sweetshooter™ will look dull on parkerized finishes. Rub some hand lotion into your hands, then massage the weapon to bring back the luster.
Surface preparation is critical. This is the key to the success of dry film lubrication. It must become part of the surface it protects. If the pore structure is not cleaned out, a continuous film cannot be formed in an effective manner. The cleaning is accomplished by the carrier/solvent.
Description of product goes here. Keep it simple and only a couple of lines.
Once is Enough for a Lifetime
If you hunt, target practice or collect firearms, you need Sweetshooter™ treatment. Sweetshooter™ is a one-time treatment that cleans, lubricates and protects your firearms. It lets you store your weapons DRY so that dust and dirt do not collect and become abrasive. After the treatment, simply use it to wipe down the outside and surface of the bore.
Directions for cleaning the surface
Cleaning the metal surface of your weapon with sweetshooter is CRITICAL!
Prepare the surface:
Remove grips or stock.
Dip your brush into Sweetshooter™ and scrub the outside vigorously.
Repeat several times until the weapon is thoroughly clean.
Now the gun is ready to TREAT!
Wet the surface of the gun with Sweetshooter™ and let it dry COMPLETELY.
Don't wet again while it's still wet or it will be as though it's the first application.
In order to hasten the drying time, use a hand held dryer for 1 hour. *But be careful because the metal will get too hot to handle.
After drying thoroughly:
Wet the metal again and repeat the drying process.
( This is the second application. )
Now do it a third time.
A Fourth time.
And then a Fifth and Final time.
You spend lots of money for your weapon and bought Sweetshooter™, so be sure to apply it correctly.
**This initial process has to be done only the FIRST time. Afterwards use a patch dipped in Sweetshooter for general cleanup.
You will be surprised by how easy it is!
Directions for cleaning and treating the barrel
The barrel gets the most stress. Therefore, treating it deep down into the pore structure will ensure greater performance as well as greater protection.
Cleaning the barrel:
(This is important, don't cheat!)
Dip your stainless steel bore brush in Sweetshooter and run it into the barrel and scrub 8 times
Dip brush again and scrub 8 times
Dip brush again and scrub 8 times
Dip brush again for the 4th and final time and scrub 8 times
Treating the barrel:
Using the same caliber stainless steel bore brush, wet the bore with Sweetshooter.
Fire a round. Then re-wet and fire again. Repeat this process at least 20 times. Be sure to wet between each round. The projectile will push the Sweetshooter down into the pores of the metal and pack it until they are full. A micro-thin film is formed inside the barrel reducing friction to a minimum causing greater accuracy, distance and velocity.
Having properly treated your weapon, all you have to do, next time you fire it, wet a patch with Sweetshooter, swab the barrel three or four times, then wipe down the outside with the same wet patch. Now you are ready to store it!
Sweetshooter TIP: If you want to put oil on your weapon, go ahead. It won't hurt anything. As you are just putting oil on the Sweetshooter film. However, oil will attract dirt, grime and grit.
Thanks to duelist1954 for the review and how-to!
Don't forget check out his other videos and SUBSCRIBE to his channel.
This channel is about guns; from the most ancient to the most modern. There is a real emphasis on historical arms and black powder shooting. But there are plenty of videos of modern guns on the channel as well.
If you like shooting, you'll like this channel.
© Copyright 2018, All Rights Reserved, Sweetshooter.com & Tecrolan.com.
Sweetshooter™ is a registered Trademark of Tecrolan™ Inc